YASKAWA E-II Series - Page 331

11 Appendix
11.3.2 List of Parameters
11-28
* 1. Normally set to “0.” When using an external regenerative resistor, set the allowable power loss (W)
of the regenerative resistor.
* 2. The upper limit is the maximum output capacity (W) of the SERVOPACK.
Parameter
No.
Name Setting Range Unit
Factory
Setting
Setting
Validation
Pn513 Input Signal Selections 5
−−0088 After restart
Pn51A Position Error Level Between Motor and
Load
0 to 32767 1 reference
unit
0 Immediately
Pn51B Reserved (Do not change)
−−100 −
Pn51C Reserved (Do not change)
−−450 −
Pn51E Excessive Position Error Warning Level
0 to 100 1 % 0 Immediately
Pn600
Regenerative Resistor Capacity
∗1
Depends on SERVO-
PACK Capacity
∗2
10 W 0 After restart
Pn601 Reserved (Do not change)
−−0 −
0
1
2
3
ON when CN1-40 input signal is ON (L-level).
ON when CN1-41 input signal is ON (L-level).
ON when CN1-42 input signal is ON (L-level).
ON when CN1-43 input signal is ON (L-level).
ON when CN1-44 input signal is ON (L-level).
ON when CN1-45 input signal is ON (L-level).
ON when CN1-40 input signal is OFF (H-level).
ON when CN1-41 input signal is OFF (H-level).
ON when CN1-42 input signal is OFF (H-level).
ON when CN1-43 input signal is OFF (H-level).
ON when CN1-44 input signal is OFF (H-level).
ON when CN1-45 input signal is OFF (H-level).
ON when CN1-46 input signal is OFF (H-level).
ON when CN1-46 input signal is ON (L-level).
Reference Pulse Input Mulitiplication Change
Reserved (Do not change)
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
4
5
6
7
8
9
A
B
C
D
E
F
Sets signal OFF. (Factory setting)
Sets signal ON.
Reserved (Do not change)
Reserved (Do not change)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com