Continued
NOTE: To establish a V/f pattern with a straight line from Fmin to F
A, set
F
B = Fmin. The setting of VC is then disregarded and does not affect the
V/f pattern.
IMPORTANT
The parameter settings are checked whenever power is applied to
the drive, or each time the ENTER key is pressed while in the
Program (PRGM) mode. A parameter set value failure ("oPE5 V/f Error ") will
occur if any part of the following relationships among n011 thru
n017 is not TRUE:
(a) Fmax ≥ F
A ≥ FB ≥ Fmin
(b) Vmax ≥ V
C ≥ Vmin
5-62
5.28 V/f PATTERN
To Next Page
Loading...
