7 Utility Functions (Fn)
7-26
(2) Related Parameters
Use the following parameters as required.
Note: Pn312 is set by the vibration detection level, so it is not necessary to adjust it.
4
Display blinks
Press the MODE/SET Key for approximately one second
again. The display shown on the left will flash and the
vibration level will be detected and refreshed. This will con-
tinue until the MODE/SET Key is pressed again.
Notes:
• Operate the SERVOPACK with the references that will
be used for actual operation.
• If the servomotor is rotating at 10% or less of the maxi-
mum speed, "Error" will be displayed.
5
Press the MODE/SET Key again at a suitable time to com-
plete vibration detection and refreshing the setting. This
will enable the setting. If the setting has been completed
normally, "donE" will be displayed. If there was a setting
failure, "Error" will be displayed.
6
Press the DATA/SHIFT Key for approximately one second.
"Fn01b" is displayed again.
Step
Display after
Operation
Keys Operation
Pn311
Vibration Detection Sensibility
Classification
Setting Range Setting Unit Factory Setting When Enabled
50 to 500 1% 100 Immediately Tuning
Pn312
Vibration Detection Level
Classification
Setting Range
Setting Unit Factory Setting
When Enabled
0 to 5000
1 min
-1
50 Immediately Tuning
Speed
Position
Torque
Speed
To Next Page
Loading...
