<Note>
Setting negative numbers
• For the parameters that accept a negative value setting, display "0000000000" and then press the DOWN
Key to set negative numbers.
• When setting negative numbers, the value increases by pressing the DOWN Key and decreases by pressing
the UP Key.
• Press the DATA/SHIFT Key to move to other digits.
• A - (minus) sign is displayed when the top two digits are displayed.
5
Press the MODE/SET Key to save the value to the SER-
VOPACK. During saving, top two digits blink. After the
saving is completed, press the DATA/SHIFT Key for
approximately one second. "Fn522" is displayed again.
Step
Display after
Operation
Keys Description
MODE
To Next Page
Loading...
