User Guide for the SIP-T19(P) E2 IP Phone
90
6. Click Confirm to accept the change.
Note
To park a call in FAC mode:
1. During a call, press the Park soft key (You may need to press the More soft key to see the
Park soft key).
- If the call park code is not configured, you need to enter the call park code.
Press , or the Park soft key.
- If the call park code is configured, the phone will dial the configured call park code
shown as below:
2. Do one of the following:
a) If you want to park the call against the local extension.
1) Press .
If the call is parked successfully, you will hear a voice prompt confirming that the call is
parked.
b) If you want to park the call against desired extension.
1) Enter an extension (e.g., 4603) where you want to park the call.
2) Press or .
If the call is parked successfully, you will hear a voice prompt confirming that the call is
parked. The call is parked against the extension you entered.
If the Park or Retrieve soft key doesn’t appear on the LCD screen, please select Disabled from
the pull-down list of Custom Softkey via web user interface at path Settings->Softkey
To Next Page
Loading...
Need help?
General