EasyManuals Logo

Yealink SIP-T19 E2 User Guide

Yealink SIP-T19 E2
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
User Guide for the SIP-T19(P) E2 IP Phone
106
The LCD screen prompts “Delete selected paging group?”.
4. Press the OK soft key to accept the change or the Cancel soft key to cancel.
If you want to delete all paging groups, you can press the Del All soft key.
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) without involving SIP signaling. You can specify up to 31
multicast addresses that the phone listens to on the network.
Note
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters configured via web user interface.
Paging Barge
The paging barge parameter defines the priority of the voice call in progress. If the priority of an
incoming multicast paging call is lower than that of the active call, it will be ignored
automatically. If Disabled is selected from the pull-down list of Paging Barge, the voice call in
progress will take precedence over all incoming multicast paging calls. Valid values in the
Paging Barge field:
1 to 31: Define the priority of the active call, 1 with the highest priority, 31 with the lowest.
Disabled: The voice call in progress will take precedence over all incoming paging calls.
Paging Priority Active
The paging priority active parameter decides how the phone handles incoming multicast paging
calls when there is already a multicast paging call on the phone. If enabled, the phone will
ignore incoming multicast paging calls with lower priorities, otherwise, the phone will answer
incoming multicast paging calls automatically and place the previous multicast paging call on
hold. If disabled, the phone will automatically ignore all incoming multicast paging calls.
RTP stream is listened in the speakerphone mode by default. If you want to listen the RTP
stream using the engaged audio device (speakerphone, handset or headset), contact your
system administrator for more information.
Fixed volume to play RTP stream for specified paging group is configurable by your system
administrator.

Table of Contents

Other manuals for Yealink SIP-T19 E2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T19 E2 and is the answer not in the manual?

Yealink SIP-T19 E2 Specifications

General IconGeneral
BrandYealink
ModelSIP-T19 E2
CategoryIP Phone
LanguageEnglish

Related product manuals