User Guide for the SIP-T19(P) E2 IP Phone
86
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Call waiting is configurable via web user interface at the path Features->General Information.
Note
Conference
You can create a conference with other two parties using the phone’s local conference. You can
create a conference between an active call and a call on hold by pressing the Conf soft key. The
SIP-T19(P) E2 IP phone also supports network conference.
Note
Local Conference
The SIP-T19(P) E2 IP phone supports up to 3 parties (including yourself) in a conference call. This
is the default method of conference called Local Conference.
Note
To set up a local conference call:
1. Place a call to the first party.
2. When the first party answers the call, press the NewCall soft key to place a new call.
The active call is placed on hold.
3. Enter the number of the second party and then press , , or the Send soft key.
4. When the second party answers the call, press the Conf soft key again to join all parties in
the conference.
You can press or to see all parties in the conference.
Network conference is not available on all servers. For more information, contact your system
administrator.
To set up a local conference call, make sure local conference feature is enabled. For more
information, contact your system administrator.
If on code or off code is not configured, the call waiting may not take effect. It depends on your
server. Contact your server administrator for more information.
To Next Page
Loading...
Need help?
General