Yealink VC110 - Page 195

Configuring Endpoint Settings
179
Parameter
Description
Configuration
Method
End Hour of Day
to Enabled.
Offset(minutes)
Configures the DST offset time
(in minutes).
Valid values: -300 to +300.
Note: It only works if the value
of the Daylight Saving Time is set
to Enabled.
Web User Interface
Time Type
Configures the DST time type.
 SNTP: obtain the time and
date from the NTP server
automatically.
 Manual Time: configure
the time and date manually.
Default: SNTP
Remote Control
Web User Interface
Time Format/ Time
Configures the time format.
 Hour12
 Hour24
Default: Hour 24
Remote Control
Web User Interface
Date Format/Date
Configures the date format.
 WWW MMM DD
 DD-MMM-YY
 YYYY-MM-DD
 DD/MM/YYYY
 MM/DD/YY
 DD MMM YYYY
 WWW DD MMM
Default: YYYY-MM-DD
Remote Control
Web User Interface
To configure the NTP server, time zone and DST via web user interface:
1. Click on Setting->Date& Time.
2. Select Disabled from the pull-down list of Manual Time.
3. Select the desired time zone from the pull-down list of Time Zone.
4. Enter the domain names or IP addresses in the Primary Server and Secondary Server
fields respectively.
5. Enter the desired time interval in the Synchronism (15~86400s) field.