Yealink VC110 - Page 244

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
228
Condition
Description
Auto Answer
When answering a call automatically
Tones parameters on the endpoint are described below:
Parameter
Description
Configuration Method
Select Country
Customizes tones or selects the
desired country tone set.
Default: Custom
Web User Interface
Ring Back
Customizes the ring-back tone for
the endpoint.
tone = element1[,element2]
[,element3]…[,element8]
Where
element =
[!]Freq1[+Freq2][+Freq3][+Freq4]
/Duration
Freq: the frequency of the tone
(ranges from 200Hz to 7000 Hz). If it
is set to 0Hz, it means the tone is not
played. A tone consists of at most
four different frequencies.
Duration: the duration (in
milliseconds) of the dial tone, ranges
from 0 to 30000ms.
You can configure at most eight
different tones for one condition,
and separate them by commas. (e.g.,
250/200, 0/1000, 200+300/500,
600+700+800+1000/2000).
If you want the endpoint to play
tones once, add an exclamation
mark “!” before tones (e.g., !250/200,
0/1000, 200+300/500,
600+700+800+1000/2000).
Default: Blank
Note: It only works if the parameter
“Select Country” is set to Custom.
Web User Interface
Busy
Customizes the busy tone for the
endpoint.
For more information on how to
Web User Interface