Yealink VC110 - Page 245

Configuring Endpoint Settings
229
Parameter
Description
Configuration Method
customize the tone, refer to the
parameter “Ring Back”.
Default: Blank
Note: It only works if the parameter
“Select Country” is set to Custom.
Call Waiting
Customizes the call waiting tone for
the endpoint.
For more information on how to
customize the tone, refer to the
parameter “Ring Back”.
Default: Blank
Note: It only works if the parameter
“Select Country” is set to Custom.
Web User Interface
Auto Answer
Customizes the auto answer tone for
the endpoint.
For more information on how to
customize the tone, refer to the
parameter “Ring Back”.
Default: Blank
Note: It only works if the parameter
“Select Country” is set to Custom.
Web User Interface
To configure tones via web user interface:
1. Click on Setting->Tones.
2. Select the desired value from the pull-down list of Select Country.
If you select Custom, you can customize the tone for indicating each condition of the
endpoint.
3. Click Confirm to accept the change.