Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
16
To remove the VCM60 from the VC110 video conferencing endpoint, do the following:
1. Remove the dongle from the VC110 all-in-one unit.
The display device prompts “Dongle remove!”. And the icon disappears from the
status bar.
Standby Mode
The VCM60 supports two standby modes: online standby and offline standby.
Online standby:
When registering with dongle successfully, the VCM60 enters online standby mode and
the mute indicator LED changes to green and is in breathing state.
Offline standby:
If VC110 video conferencing endpoint encounters poor signal, wireless interference or is
powered off, the VCM60 may lose connection with the dongle. In this case, the VCM60 will
search for the dongle again, and the mute indicator LED fast flashes green. If dongle
cannot be searched in 2 minutes, the VCM60 will enter offline standby mode automatically
and the mute indicator LED slowly flashes orange.
When the VCM60 is in offline standby mode, you need to tap the mute button to activate
VCM60 to search for dongle again and the mute indicator LED fast flashes green.
To Next Page
Loading...
