Yealink VC110 - Page 88

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
72
TLV Type
TLV Name
Description
enabled by default.
Port Description
Description of port that sends data unit.
The default value is “WAN PORT”.
IEEE Std 802.3
Organizationally
Specific TLV
MAC/PHY
Configuration/Status
Duplex mode and network speed settings of
the endpoint.
The Auto Negotiation is supported and
enabled by default.
The advertised capabilities of PMD.
Auto-Negotiation is:
100BASE-TX (full duplex mode)
100BASE-TX (half duplex mode)
10BASE-T (full duplex mode)
10BASE-T (half duplex mode)
TIA
Organizationally
Specific TLVs
Media Capabilities
The MED device type of the endpoint and the
supported LLDP-MED TLV type can be
encapsulated in LLDPDU.
The supported LLDP-MED TLV types are:
LLDP-MED Capabilities, Network Policy,
Extended Power via MDI-PD, Inventory.
Network Policy
Port VLAN ID, application type, L2 priority
and DSCP value.
Extended
Power-via-MDI
Power type, source, priority and value.
Inventory – Hardware
Revision
Hardware revision of the endpoint.
Inventory – Firmware
Revision
Firmware revision of the endpoint.
Inventory – Software
Revision
Software revision of the endpoint.
Inventory – Serial
Number
Serial number of the endpoint.
Inventory –
Manufacturer Name
Manufacturer name of the endpoint.
The default value is “IP_Phone”.
Inventory – Model
Name
Model name of the endpoint.
The default value is “VC110”.