Yealink VC110 - Page 89

Configuring Network
73
TLV Type
TLV Name
Description
Asset ID
Assertion identifier of the endpoint.
Parameters of LLDP feature on the endpoint are described below.
Parameter
Description
Configuration Method
LLDP->Active
Enables or disables LLDP feature on
the endpoint.
Default: Enabled
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Packet
Interval(1-3600s)
Configures the interval (in seconds)
for the endpoint to send LLDP
requests.
Default: 60
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure LLDP via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet Interval (1-3600s) field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click Confirm to reboot the endpoint immediately.