Yealink VC110 - Page 159

Configuring Endpoint Settings
149
Parameter
Description
Configuration Method
Default: 0
Note: You can set this parameter
only when the white balance
mode is configured to Manual.
Blue Gain
Configures the blue gain of the
camera.
Valid Values: 0-100
Default: 0
Note: You can set this parameter
only when the white balance
mode is configured to Manual.
Remote Control
Web User Interface
Saturation
Configures the saturation of the
camera.
Valid Values: 0-14
Default: 7
Remote Control
Web User Interface
Sharpness
Configures the sharpness of the
camera.
Valid Values: 0-14
Default: 1
Note: The picture will be sharp
and clear, but moderate to heavy
motion at low call rates can
cause some frames to be
dropped.
Remote Control
Web User Interface
Brightness
Configures the brightness of the
camera.
Valid Values: 0-100
Default: 50
Remote Control
Web User Interface
Contrast
Configures the contrast of the
camera.
Valid Values: 0-100
Default: 50
Remote Control
Web User Interface
Noise Reduction
(2D)
Specifies the noise reduction (2D)
mode.
 Off
 Low
Remote Control
Web User Interface