YOKOGAWA AQ1215A - Page 130

6-22
IM AQ1210-01EN
Setting the Start and End Points
7.
Move the cursor to the start point position. For the cursor operation procedure, see section 6.1.
8.
Tap the Set Start Marker soft key to display the S marker.
9.
Move the cursor to the end point position.
10.
Tap the Set End Marker soft key to display the E marker.
Start point
Shows marker S. If a reference point (marker ) is not specified using
reference point adjustment, the start point becomes the reference point.
B
End point
Shows marker E
The level at the reference point
(marker S)
Section analysis values
between the start point and
end point
Setting the Start or End Point to a Set Marker (
1
,
2
, n, or E)
7.
Tap the To be set by Marker soft key. The position of marker
1
or n already set on the
waveform data changes to a start point and the position of marker
2
or E changes to an end
point.
1 2
Markers and
Tap the To be set by
Marker soft key.
Markers S and E
Note
For details on how to set markers
1
,
2
, n, and E, see section 6.1.
6.4 Analyzing Sections