3-5
IM AQ1210-01EN
Performing Real-time Measurement
3
Switching the Display between TRACE Mode and MAP Mode
When you start a real-time measurement, the data display screen automatically switches to TRACE
mode.
Saving Waveforms during Real-Time Measurement
If you save waveforms during real-time measurement, waveform data at that point is saved in
memory. If real-time measurement has been completed, waveforms shown on the data display
screen are saved in memory. If event analysis is performed on real-time measurement waveforms,
MAP display data is also saved in memory.
3.1 Performing Real-time Measurement
To Next Page
Loading...
Need help?
General
