EasyManua.ls Logo

YOKOGAWA GX20 - Page 648

YOKOGAWA GX20
707 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
All Rights Reserved. Copyright © 2012, Yokogawa Electric Corporation
GS 04L52B01-01EN
June. 14, 2017-00
FAILOUTPUT(/FL)
• Contact:Ccontact,1point
• FAILoutput:
The relay contact output on the rear panel
indicatestheoccurrenceofCPUfailure.
Relayoperation:Energizedduringnormal
operationandde-energizedonCPUfailure.
• Statusoutput:Therelaycontact,whichisde-
energizedinnormaloutputstate,isenergized
upontheoccurrenceofamemory/mediaerror,
measurementerror,communicationerror,
recordingstop,oralarm.
• Ratedpowersupplyvoltage:24VDCor250V
AC or less
• Ratedloadcurrent:3A(DC)/3A(AC),resistance
load
• Min.loadcurrent:100mA
• Recommendedreplacementperiodsofcontact:
Electrical:30,000moreON-OFFoperations,
Mechanical:5,000,000moreON-OFFoperations
LogSCALE(/LG)
Alogarithmicvoltagethathasbeenconvertedfrom
aphysicalvalueisappliedtotheGP,andthenthe
GP’sLogscale(logarithmicscale)isusedtodisplay
andrecordthephysicalvalue.
• Inputtype:Loginput(logarithmicinput),Pseudo
log input: An input that supports pseudo
logs,Loglinearinput:Inputthatislinearona
logarithmicscale.
• Range:20mV/60mV/200mV/1V/2V/6V/20V/50V/
100V
• Scalablerange:
• Loginput:
1.00E-15to1.00E+15(15decade
maximum)
Scale_L<Scale_U
Ifthelowerlimitmantissais1.00,the
differencebetweentheexponentsmustbe
1ormore.
Ifthelowerlimitmantissaisavalueother
than1.00,thedifferencebetweenthe
exponentsmustbe2ormore.
• PseudoLogInput/Loglinearinput
1.00E-15to1.00E+15(15decade
maximum)
Thehigherlimitmantissaisthesameas
thelowerlimitmantissa).
Ifthelowerlimitmantissais1.00,thevalue
mustbebetween1.00E–15and1.00E+15,
thedifferencebetweentheexponentsmust
be1ormore,andthemaximumdecadesis
15.
Ifthelowerlimitmantissaisavalueother
than1.00,thevaluemustbebetween
1.01E–15and9.99E+14,thedifference
betweentheexponentsmustbe1ormore
andthemaximumdecadesis15.
• Alarmtype:Highlimit,lowlimit,delayhighlimit,
anddelaylowlimit
• Alarmsettingrange:Therangeconvertedinto
theLOGscalecorrespondingto-5%to105%of
the span width.
• Alarmhysteresis:Fixedto0
• Greenbandsettingrange:Thelowerlimittothe
upperlimitofthescale.However,thelowerlimit
ofthedisplaypositionmustbesmallerthanthe
upperlimit.
• Positionofthedecimalpoint:1to2
• Misc:Nonlinearinputispossiblebycorrecting
theinputvalue
MATHEMATICAL FUNCTIONS WITH REPORT
FUNCTION(/MT)
MathematicalFunction:
• Numberofmathchannels;GP10:50,GP20-1:
100, GP20-2: 200
Note) Note:Dependingonthemeasurementmode,
thereisalimittothenumberofmathchannels
atscanintervalsshorterthan100ms.See
“Limitations.”
• Scaninterval
Measurementmode Scaninterval
Normal Scaninterval
High speed Scaninterval
Dualinterval Masterscaninterval*
* WhenthemeasurementmodeisDualinterval,
thisitemsetswhichscanintervaltouse,the
intervalofmeasurementgroup1orthatofscan
group2,forcreatingmeasuredvaluesofmath
orcommunicationchannelsandothersimilar
operations.
• Numberofexpressions:
• Operation:
Generalarithmeticoperations:Fourarithmetic
operations(+,-,*,/),squareroot,absolute,
commonlogarithm,naturallogarithm,
exponential,andpower
Relationaloperations:<,≤,>,≥,=,and≠
Logicoperations:AND,OR,NOT,andXOR
Statisticaloperations:TLOG(maximum,
minimum,average,sum,P-Pvaluesoftime
seriesdata)orCLOG(maximum,minimum,
average,sum,P-Pvaluesofaspeciedchannel)
Specialoperations:PRE,HOLD,RESET,and
CARRY
Conditionaloperation:[a?b:c]
Bitoperation:BIT
Integerextractingoperation:INT
Remainderextractingoperation:MOD
Trigonometricfunctions:SIN,COS
CP operations: CP.02, CP.CO2
• Computationaccuracy:Double-precisionoating
point
• Datathatcanbeused;
Channeldata:Measurementchannels(0001to
6516to6516),mathematicalchannels(GP10:
A001 to A050, GP20-1: A001 to A100, GP20-2:
A001toA200),Communicationchannels(GP10:
C001 to C050, GP20-1: C001 to C300, GP20-2:
C001toC500),Communicationchannelsraw
data (GP10: RC001 to RC050, GP20-1: C001
to C300,GP20-2: RC001 to RC500),Constants:
K001toK100,Variableconstant:W001toW100,
Internalswitch:S001toS100,Flag:F01toF20,
Recording state (REC01), Integer data: Z000 to
Z999

Table of Contents

Related product manuals