User’s Manual 1PH HYD3000-HYD6000-ZSS
Rev. 1.1 16/03/2021
Identification: MD-AL-GI-00
Rev. 1.1 of 16/03/2021 - Application: GID
3.6. Assembly instructions
Step 1: Position the mounting bracket on the wall, mark the 8 fixing points using the marker. Drill 8 holes (6 mm
drill bit) in the wall.
Step 2: Insert the expansion screws vertically into the hole, make sure that the insertion depth is neither too
shallow nor too deep.
Step 3: Fix the mounting bracket to the wall using dowels and flat washers.
Step 4: Place the 1PH HYD3000-HYD6000-ZSS inverter on the mounting bracket.
Step 5: Use the grounding hole of the heatsink to ground the 1PH HYD3000-HYD6000-ZSS inverter.
Step 6: OPTIONAL: the 1PH HYD3000-HYD6000-ZSS inverter can be fixed to the mounting bracket.
Note: For safety reasons, ZCS Spa and/or its partners may not carry out any technical repairs or maintenance
work, or move the inverter or battery packs from and to the ground if they are installed at a height of more than
180 cm from the ground.
To Next Page
Loading...
