User’s Manual 1PH HYD3000-HYD6000-ZSS
Rev. 1.1 16/03/2021
Identification: MD-AL-GI-00
Rev. 1.1 of 16/03/2021 - Application: GID
1. Introduction
The 1PH HYD3000-HYD6000-ZSS hybrid inverter is used in photovoltaic systems with battery storage. The
system can be combined with WeCo and Pylontech batteries supplied in kit form by ZCS Azzurro.
The energy produced by the photovoltaic system will be optimised for maximum self-consumption.
The 1PH HYD3000-HYD6000-ZSS inverter can operate in automatic mode and in time-of-use charge,
charge/discharge mode. In automatic mode, when the energy produced by the PV field is greater than that
required by the utilities, the 1PH HYD3000-HYD6000-ZSS inverter charges the battery using the photovoltaic
energy in excess, and when the photovoltaic energy is lower than that required, the inverter uses the energy
stored in the battery to supply current to the local load.
In the event of a power failure (or by switching on the inverter in Off-Grid mode), the 1PH HYD3000-HYD6000-
ZSS inverter can operate in Emergency Power Supply (EPS) mode. The 1PH HYD3000-HYD6000-ZSS inverter
will use both the energy created by the photovoltaic panels and the energy stored in the battery to supply
energy to the critical load.
Figure 1 - Diagram of a system on which an 1PH HYD3000-HYD6000-ZSS hybrid is installed
To Next Page
Loading...
