86 R110Xi/R170Xi User Guide 12/6/04 23063L-003 Rev. 1
RFID Guidelines
^RR
^RR
Specify RFID Retries for a Block
Description This command changes the number of times that the printer attempts to read or
write to a particular block of a single RFID tag. By default, the printer will attempt six retries.
This command is persistent and will be used in subsequent formats if not provided.
Format
^RRn
The following table identifies the parameters for this format.
Important • This command is not the same as the number of labels to try parameter in the
^RS command.
Parameters Details
n = number of retries Accepted values: 0 to 10
Default value: 0
Examples •
Set read block retries to 5
^XA
^FN1^RR5^RFR,H^FS
^HV1^FS
^XZ
Set write block retries to 2
^XA
^RR2^RFW,H^FD1234^FS
^XZ
To Next Page
Loading...
