RFID Guidelines
^WV
23063L-003 Rev. 1 12/6/04 R110Xi/R170Xi User Guide 97
^WV
Verify RFID Write Operation
Description If write verify is enabled, this command verifies the RFID write operation to
ensure that the tag about to be programmed contains the hex data “A5A5” in the first two
bytes. This parameter is not persistent (carried over from label to label).
Format
^WVe
The following table identifies the parameters for this format.
Important • This command is valid with Class 1 Alien tags only.
Parameters Details
e =enable Accepted values: Y or N
Default value: N
To Next Page
Loading...
