RFID Guidelines
^RM
23063L-003 Rev. 1 12/6/04 R110Xi/R170Xi User Guide 85
^RM
Enable RFID Motion
Description This command enables or disables RFID motion. By default, labels
automatically print at the end of the format. This command allows you to inhibit the label from
actually moving when it reaches the program position, which is useful for debugging, setup,
and custom applications. This parameter is not persistent (carried over from label to label).
Format
^RMe
The following table identifies the parameters for this format.
Parameters Details
e =enable Accepted values: Y (Yes, move the label), N (No, do not move the label)
Default value: Y
To Next Page
Loading...
