Accessories
139
Condensation Resistant Rear Bezel Replacement
The Condensation Resistant configurations contain a desiccant pack that must be replaced every five
months. The desiccant pack is part of the Back Bezel. Replacement Back Bezel with desiccant pack
comes in a vacuum sealed package. Do not open the package until instructed in the steps below. Install
immediately after opening.
To replace the Back Bezel:
1. Remove six screws securing the Back Bezel.
Figure 99 Remove Screws
2. Lift Rear Bezel.
Figure 100 Lift Rear Bezel
To Next Page
Loading...
