Data Capture
71
Pairing the RS507 Hands-Free Imager Using SSI
An RS507 Hands-free Imager can be used with the device to capture barcode data.
1. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
2. Install the battery into the RS507.
3. Swipe up from the bottom of the Home screen and touch .
Figure 33 Bluetooth Pairing Utility
4. Using the RS507, scan the barcode on the screen.
The RS507 emits a high/low/high/low beeps. The Scan LED flashes green indicating that the RS507 is
attempting to establish connection with the device. When connection is established, the Scan LED
turns off and the RS507 emits one string of low/high beeps.
5. On the device, touch .
Pairing the RS507 Hands-Free Imager Using Bluetooth HID
An RS507 Hands-free Imager can be used with the device to capture barcode data.
1. Ensure that Bluetooth is enabled on both devices.
2. Ensure that the Bluetooth device to discover is in discoverable mode.
3. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
4. Place the RS507 in Human Interface Device (HID) mode. If the RS507 is already in HID mode, skip to
step 5.
a. Remove the battery from the RS507.
b. Press and hold the Restore key.
c. Install the battery onto the RS507.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
