P1075391-001 • ZQ520 Repair Procedures • 2-20 •
Display Module Assembly
Installation Instructions
This kit includes the parts necessary to install Display Module Assembly
P1063406-010. Read these instructions thoroughly before attempting to install this
kit.
Tools Required
• N/A
Removing the Display Module Assembly
1. Remove the Printer Chassis from
the Main Housing as described on
Page 2-16 to 2-17.
2. Disconnect the User Interface
cable from J29 on the Main Logic
Board (MLB) as shown in Step 6 on
Page 2-17.
3. Lift the Display Module Assembly
from the Main Housing (as shown).
Installing the Display Module Assembly
1. Slide the Display Module into the
front of the Main Housing ensuring
that the buttons on the keypad are
accessible through the opening in
the Main Housing.
2. Connect the User Interface cable
to J29 on the MLB.
3. Reassemble the printer.
To Next Page
Loading...