P1075391-001 • ZQ520 Repair Procedures • 2-29 •
Removing the Motor Assembly
1. Remove the Printer Chassis from
the Main Housing as previously
described on Page 2-16 & 2-17.
2. Remove the NFC Bracket if
present as shown on 2-18.
3. Disconnect the Motor Cable (J8),
the Black Bar Cable (J4), the Gap
Sensor Cable (J3), the Head Up
Cable (J5) on the Top PCBA.
4. Remove nine (9) screws located
on the PCBA Mounting Bracket
(where shown) with a T-8 TORX
driver.
5. Disconnect the Printhead Cable
from the MLB to separate the
Printer Frame from the PCBA
Mounting Bracket (as shown).
Motor Assembly
Installation Instructions
This kit includes the parts necessary to install the P1072539-007 Motor Assembly
Kit in the ZQ520 printer. Read these instructions thoroughly before attempting to
install this kit.
Tools Required: T-8 TORX Driver (4.7 +/- 1 in. lb. & 2.5 +/- 1 in. lb.)
To Next Page
Loading...