P1075391-001 • ZQ520 Repair Procedures • 2-46 •
Removing the Mag Card Reader
1. Locate the two (2) screws on
the front of the printer (circled)
securing the Mag Card Reader
Assembly to the Lower Housing.
2. Use a T-8 TORX driver to remove
each screw.
3. Pull the Mag Card Reader and
Reader Bumper straight out from
the printer to remove (as shown).
Mag Card Reader
Installation Instructions
This kit includes the parts and documentation necessary to install the
P1072539-014 Mag Card Reader. Read these instructions thoroughly before
attempting to install this kit.
Tools Required: T-8 TORX Driver (4.7 +/- 1 in. lb.)
To Next Page
Loading...