P1075391-001 • ZQ520 Repair Procedures • 2-41 •
Installing the Media Guide
Assembly
1. Install the Media Guide Bar onto
the Media Guide Plate (where
shown).
2. Install the corresponding Media
Support onto the Media Guide
Bar. Use a T-10 TORX driver (4.7
+/- in. lb.) to secure with screw
provided.
3. Repeat the above steps for the
other Media Support.
4. Install the Media Guide Belt
around the Media Guides (as
shown). (Be sure to insert the
raised portion of the belt into
notches (circled) on the Media
Guides.
5. Install the two (2) Belt Pulleys
on their respective posts on the
Media Guide Plate (circled).
6. Install each end of the spring on
the Media Guide (where shown).
Repeat for the other spring on the
opposite Media Guide.
7. Verify the orientation of the
Media Supports.
To Next Page
Loading...