Printer Setup
34
12.
Rotate the printhead-open lever downward until it locks the printhead in place.
13. Close the media door.
14. Set the printer to the appropriate collection method (for more information, see Print > Label Position >
Collection Method on page 77).
15. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
16. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors on page 89.
17. If desired, print a configuration or other label to verify that your printer is able to print. (See System >
Settings > Print: System Settings on page 64.)
Media loading in Peel-Off mode is complete.
To Next Page
Loading...