Printer Configuration and Adjustment
77
Print > Print Quality > Label Length
View the calibrated label length in dots. This value cannot be modified.
Print > Print Quality > Label Width (Dots)
Specify the width of the labels being used, in dots. The default value is the maximum width for
the printer, based on the printhead’s DPI value.
Accepted values: NOTE: Setting the width too narrow can result in portions
of a label format not being printed on the media. Setting
the width too wide wastes formatting memory and can
cause the printer to print off of the label and onto the platen
roller. This setting can affect the horizontal position of the
label format if the image was inverted using the
^POI
ZPL II command.
ZT411 203 dpi = 0002 to 832
ZT411 300 dpi = 0002 to 1248
ZT411 600 dpi = 0002 to 2496
ZT421 203 dpi = 0002 to 1344
ZT421 300 dpi = 0002 to 1984
Related ZPL command(s):
^PW
SGD command used:
ezpl.print_width
Printer web page: View and Modify Printer Settings > Media Setup > Print Width
Print > Label Position > Collection Method
Select a collection method that is compatible with the options available on your printer.
Accepted values: Tear Off, Peel Off, Rewind, Cutter, Delayed Cut, Linerless Peel,
Linerless Rewind, Linerless Tear, Applicator, Linerless Cut,
Linerless Delayed Cut
Related ZPL command(s):
^MM
SGD command used:
media.printmode
Printer web page: View and Modify Printer Settings > General Setup > Print Mode
To Next Page
Loading...