Printer Configuration and Adjustment
78
Print > Label Position > Tear Line Offset
If necessary, shift the position of the media over the tear-off bar after printing.
• Lower numbers move the media into the printer by the specified number of dots (the tear
line moves closer to the edge of the label just printed).
• Higher numbers move the media out of the printer (the tear line moves closer to the leading
edge of the next label).
Accepted values: –120 to +120
Related ZPL command(s):
~TA
SGD command used: ezpl.tear_off
Printer web page: View and Modify Printer Settings > General Setup > Tear Off
To Next Page
Loading...