Zebra ZT411 - Page 79

Printer Configuration and Adjustment
79
Print > Label Position > Label Offset
If necessary, shift the position of the image horizontally or vertically on the label.
Horizontal
• Negative numbers move the left edge of the image toward the left edge of the label by the
number of dots selected.
• Positive numbers move the edge of the image toward the right edge of the label.
Accepted values: –9999 to 9999
Related ZPL command(s):
^LS
SGD command used:
zpl.left_position
Printer web page: View and Modify Printer Settings > Advanced Setup > Left
Position
Vertical
• Lower numbers move the image higher on the label (toward the printhead).
• Higher numbers move the image farther down on the label (away from the printhead) by the
specified number of dots.
Accepted values: –120 to +120
Related ZPL command(s):
^LT
Printer web page: View and Modify Printer Settings > General Setup > Label Top