Zebra ZT411 - Page 62

Printer Configuration and Adjustment
62
System > Settings > Power Up Action
Set the action for the printer to take during the power-up sequence.
Accepted values: CALIBRATE—Adjusts sensor levels and thresholds, determines
the label length, and feeds the media to the next web.
FEED—Feeds the labels to the first registration point.
LENGTH—Determines the label length using current sensor
values, and feeds the media to the next web.
NO MOTION—Tells the printer not to move the media. You must
manually ensure that the web is positioned correctly, or press feed
to position the next web.
SHORT CAL—Sets the media and web thresholds without
adjusting sensor gain, determines the label length, and feeds the
media to the next web.
Related ZPL command(s):
^MF
SGD command used:
ezpl.power_up_action
Printer web page: View and Modify Printer Settings > Calibration
System > Settings > Head Close Action
Set the action for the printer to take when you close the printhead.
Accepted values: CALIBRATE—Adjusts sensor levels and thresholds, determines
the label length, and feeds the media to the next web.
FEED—Feeds the labels to the first registration point.
LENGTH—Determines the label length using current sensor
values, and feeds the media to the next web.
NO MOTION—Tells the printer not to move the media. You must
manually ensure that the web is positioned correctly, or press feed
to position the next web.
SHORT CAL—Sets the media and web thresholds without
adjusting sensor gain, determines the label length, and feeds the
media to the next web.
Related ZPL command(s):
^MF
SGD command used:
ezpl.head_close_action
Printer web page: View and Modify Printer Settings > Calibration