Zebra ZT411 - Page 69

Printer Configuration and Adjustment
69
Connection > Wired > Wired Subnet
View and, if necessary, change the wired subnet mask.
To save changes to this setting, set Connection > Wired > Wired IP Protocol on page 68 to
PERMANENT, and then reset the print server (see Connection > Networks > Reset Network on
page 65).
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.netmask
Printer web page: View and Modify Printer Settings > Network Communications
Setup > TCP/IP Settings
Connection > Wired > Wired Gateway
View and, if necessary, change the default wired gateway.
To save changes to this setting, set Connection > Wired > Wired IP Protocol on page 68 to
PERMANENT, and then reset the print server (see Connection > Networks > Reset Network on
page 65).
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.gateway
Printer web page: View and Modify Printer Settings > Network Communications
Setup > TCP/IP Settings
Connection > Wired > Wired Mac Address
View the Media Access Control (MAC) address of the wired print server. This value cannot be
modified.
SGD command used:
internal_wired.mac_addr
Printer web page: View and Modify Printer Settings > Network Communications
Setup > TCP/IP Settings