Zebra ZT411 - Page 68

Printer Configuration and Adjustment
68
Connection > Networks > Visibility Agent
When the printer is connected to a wired or wireless network, it will attempt to connect to
Zebra’s Asset Visibility Service via the Cloud-based Zebra Printer Connector using an
encrypted, certificate-authenticated web socket connection. The printer sends Discovery Data
and Settings and Alerts Data. Data printed via any label formats is NOT transmitted.
To opt out of this feature, disable this setting. For more information, see the “Opting Out of the
Asset Visibility Agent” application note at http://www.zebra.com.
Accepted values: ON, OFF
SGD command used:
weblink.zebra_connector.enable
Printer web page: View and Modify Printer Settings > Network Configuration > Cloud
Connect Settings
Connection > Wired > Wired IP Protocol
This parameter indicates if the user (permanent) or the server (dynamic) selects the wired print
server’s IP address. When a dynamic option is chosen, this parameter tells the method(s) by
which this print server receives the IP address from the server.
IMPORTANT: You must reset the print server to allow changes to the network settings
to take effect. See Connection > Networks > Reset Network on page 65.
Accepted values: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP & BOOTP, PERMANENT
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.protocol
Printer web page: View and Modify Printer Settings > Network Communications
Setup > TCP/IP Settings
Connection > Wired > Wired IP Address
View and, if necessary, change the printer’s wired IP address.
To save changes to this setting, set Connection > Wired > Wired IP Protocol on page 68 to
PERMANENT, and then reset the print server (see Connection > Networks > Reset Network on
page 65).
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.addr
Printer web page: View and Modify Printer Settings > Network Communications
Setup > TCP/IP Settings