Zebra ZT411 - Page 85

Printer Configuration and Adjustment
85
RFID > RFID Antenna
If the desired antenna is not achieved through RFID tag calibration, a value may be specified.
Accepted values: A1, A2, A3, A4
B1, B2, B3, B4
C1, C2, C3, C4
D1, D2, D3, D4
E1, E2, E3, E4
Related ZPL command(s):
^RW
SGD command used:
rfid.reader_1.antenna_port
Printer web page: View and Modify Printer Settings > RFID Setup > RFID ANTENNA
RFID > RFID Valid Count
Resets the RFID valid label counter to zero.
Related ZPL command(s):
~RO
SGD command used:
odometer.rfid.valid_resettable
RFID > RFID Void Count
Resets the RFID void label counter to zero.
Related ZPL command(s):
~RO
SGD command used:
odometer.rfid.void_resettable