Printer Configuration and Adjustment
86
RFID > RFID Program Position
If the desired programming position (read/write position) is not achieved through RFID tag
calibration, a value may be specified.
Accepted values: F0 to Fxxx (where xxx is the label length in millimeters or 999,
whichever is less)—The printer feeds the label forward for the
specified distance and then begins programming.
B0 to B30—The printer backfeeds the label for the specified
distance and then begins programming. To account for the
backfeed, allow empty media liner to extend out of the front of the
printer when using a backward programming position.
Related ZPL command(s):
^RS
SGD command used:
rfid.position.program
Printer web page: View and Modify Printer Settings > RFID Setup > PROGRAM
POSITION
RFID > Read RFID Data
Read and return the specified tag data from the RFID tag located over the RFID antenna. No
printer movement occurs while tag data is being read. The printhead can be open or closed.
To read and display the information stored on an RFID tag:
1. Position the RFID label with its transponder over the RFID antenna.
2. Touch Read RFID Data.
The results of the test are shown on the display.
Related ZPL command(s):
^RF
SGD command used:
rfid.tag.read.content
rfid.tag.read.execute
To Next Page
Loading...