Zebra ZT610 - COMMAND CHAR

Printer Configuration and Adjustment
Adjust Printer Settings
172
P1088680-001 ZT600 Series™ User Guide 5/22/17
LANGUAGE > COMMAND CHAR
The format command prefix is a two-digit hex value used as a parameter place marker in
ZPL/ZPL II format instructions. The printer looks for this hex character to indicate the start of
a ZPL/ZPL II format instruction.
Set the format command character to match what is used in your label formats.
Important • You cannot use the same hex value for the format command prefix,
control character, and delimiter characters. The printer must see different characters to
work properly. If you are setting the value through the control panel, the printer will
skip any value that is already in use.
LANGUAGE
—
LANGUAGE
—
COMMAND LANGUAGE
—
COMMAND CHAR
—
CONTROL CHAR
—
DELIMITER CHAR
—
ZPL MODE
—
VIRTUAL DEVICE
Accepted values: 00 to FF
Related ZPL command(s):
^CC
or
~CC
SGD command used: zpl.caret
Printer web page: View and Modify Printer Settings > ZPL Control