Zebra ZT610 - RFID TEST

163
Printer Configuration and Adjustment
Adjust Printer Settings
5/22/17 ZT600 Series™ User Guide P1088680-001
RFID > RFID TEST
During the RFID test, the printer attempts to read and write to a transponder. No printer
movement occurs with this test.
To test an RFID label:
1. Position the RFID label with its transponder over the RFID antenna array.
2. Press RIGHT SELECT to select START.
The results of the test are shown on the display.
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
Accepted values: quick—Performs a read EPC test and a write EPC test (using random data).
read—Performs a read EPC test.
write—Performs a write EPC test (using random data).
SGD command used:
rfid.tag.test.content and rfid.tag.test.execute