Zebra ZT610 - NETWORK > WIRED IP ADDRESS

143
Printer Configuration and Adjustment
Adjust Printer Settings
5/22/17 ZT600 Series™ User Guide P1088680-001
NETWORK > WIRED IP ADDRESS
View and, if necessary, change the printer’s wired IP address.
To save changes to this setting, set WIRED IP PROTOCOL on page 146 to
PERMANENT, and
then reset the print server (see RESET NETWORK on page 158). See IP Address Changing
on page 259 for additional information.
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.addr
Printer web page: View and Modify Printer Settings > Network Communications Setup >
TCP/IP Settings