Specifications
Ribbon Specifications
286
P1088680-001 ZT600 Series™ User Guide 5/22/17
Ribbon Specifications
Standard printers use ribbon that is coated on the outside. An optional ribbon spindle is
available to use ribbon that is coated on the inside. Contact your authorized Zebra reseller for
ordering information.
ZT610 ZT620
Ribbon width MINIMUM* 0.79 in. (20 mm) 2 in.** (51 mm**)
Ribbon width MAXIMUM 4.33 in. (110 mm) 6.7 in. (170 mm)
Ribbon length MAXIUMUM 1476 ft (450 m)
Ribbon core inside diameter 1 in. (25 mm)
Ribbon roll outside diameter MAXIMUM 3.2 in. (81.3 mm)
* Zebra recommends using ribbon that is at least as wide as the media to protect the printhead from wear.
** Depending on your application, you may be able to use ribbon narrower than 2 in. (51 mm), as long as the ribbon is wider
than the media being used. To use a narrower ribbon, test the ribbon’s performance with your media to assure that you get the
desired results.
To Next Page
Loading...