Printer Configuration and Adjustment
Adjust the Sensor Position
204
P1088680-001 ZT600 Series™ User Guide 5/22/17
Adjust the Sensor Position
The transmissive media sensor assembly consists of two parts: a light source and a light
sensor. The lower part of the media sensor is the light source, and the upper part of the media
sensor is the light sensor. The media passes between the two parts.
Adjust the position of the sensor only if the printer cannot detect the top of the labels. In this
situation, the display shows a media out error even though there is media loaded in the printer.
For non-continuous media with a notch or hole, the sensor must be positioned directly at the
notch or hole.
To adjust the transmissive media sensor position, complete these steps:
1. Remove the ribbon so you can clearly see the media path.
2. With media loaded, locate the green light that shines from the lower part of the media
sensor.
3. If necessary, turn the gold transmissive sensor adjustment wheel to move the sensor until it
is positioned at a notch or hole in the media.
To Next Page
Loading...