Zebra ZT610 - READ RFID DATA

Printer Configuration and Adjustment
Adjust Printer Settings
162
P1088680-001 ZT600 Series™ User Guide 5/22/17
RFID > READ RFID DATA
Read and return the specified tag data from the RFID tag located over the RFID antenna. No
printer movement occurs while tag data is being read. The printhead can be open or closed.
To read and display the information stored on an RFID tag:
1. Position the RFID label with its transponder over the RFID antenna.
2. Use the UP ARROW or DOWN ARROW to select the type of information that you want
read and displayed.
3. Press RIGHT SELECT to select READ.
The results of the test are shown on the display.
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
Accepted values: epc—Reads the first 128 bits of EPC data.
tid information—Reads the first 32 bits of the TID (Tag ID).
password status—Reads the tag’s access and kill passwords.
protocol bits—Reads the protocol bits from the EPC memory banks and
converts that value to the EPC size.
memory bank sizes—Reads the EPC, TID, and user memory banks sizes.
Related ZPL command(s):
^RF
SGD command used:
rfid.tag.read.content
rfid.tag.read.execute