179
Printer Configuration and Adjustment
Adjust Printer Settings
5/22/17 ZT600 Series™ User Guide P1088680-001
SENSORS > LABEL SENSOR
Set the sensitivity of the label sensor.
Important • This value is set during sensor calibration. Do not change this setting unless you
are told to do so by Zebra Technical Support or by an authorized service technician.
SENSORS
—
SENSOR TYPE
—
MEDIA/RIBBON CAL
—
PRINT INFORMATION
—
SELF ADJUST SENSOR
—
LABEL SENSOR
—
TAKE LABEL
Accepted values: 0 to 255
SGD command used:
ezpl.label_sensor
Printer web page: View and Modify Printer Settings > Calibration
To Next Page
Loading...