Printer Configuration and Adjustment
Adjust Printer Settings
164
P1088680-001 ZT600 Series™ User Guide 5/22/17
RFID > RFID PROGRAM POS.
If the desired programming position (read/write position) is not achieved through RFID tag
calibration, a value may be specified.
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
Accepted values: F0 to Fxxx (where xxx is the label length in millimeters or 999, whichever is
less)—The printer feeds the label forward for the specified distance and
then begins programming.
B0 to B30—The printer backfeeds the label for the specified distance and then
begins programming. To account for the backfeed, allow empty media
liner to extend out of the front of the printer when using a backward
programming position.
Related ZPL command(s):
^RS
SGD command used:
rfid.position.program
Printer web page: View and Modify Printer Settings > RFID Setup > PROGRAM POSITION
To Next Page
Loading...