213
Routine Maintenance
Cleaning Schedule and Procedures
5/22/17 ZT600 Series™ User Guide P1088680-001
Clean the Exterior, the Media Compartment, and the Sensors
Over time, dust, grime, and other debris may build up on the outside and inside of your printer,
particularly in a harsh operating environment.
Printer Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
Media Compartment and Sensors
To clean the sensors, complete these steps:
1. Brush, air blow, or vacuum any accumulated paper lint and dust away from the media and
ribbon paths.
2. Brush, air blow, or vacuum any accumulated paper lint and dust away from the sensors.
Important • Zebra is not responsible for damage caused by the use of cleaning fluids on this
printer.
1
Take-label sensor
2
Ribbon sensor
3
Media sensor
To Next Page
Loading...