161
Printer Configuration and Adjustment
Adjust Printer Settings
5/22/17 ZT600 Series™ User Guide P1088680-001
RFID > RFID CALIBRATE
Initiate tag calibration for RFID media. (Not the same as media and ribbon calibration.)
During the process, the printer moves the media, calibrates the RFID tag position, and
determines the optimal settings for the RFID media being used. These settings include the
programming position, the antenna element to use, and the read/write power level to use. See
the RFID Programming Guide 3 for more information.
n
Important • Before running this command, load the printer with RFID media, calibrate your
printer, close the printhead, and feed at least one label to make sure that tag calibration will
begin from the correct position.
Leave all transponders before and after the tag that is being calibrated. This allows the printer
to determine RFID settings which do not encode the adjacent tag. Allow a portion of media
to extend out the front of the printer to allow for backfeed during the tag calibration
procedure.
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
Related ZPL command(s): ^HR
SGD command used:
rfid.tag.calibrate
To Next Page
Loading...