Zebra ZT610 - TOOLS > MEDIA;RIBBON CAL

127
Printer Configuration and Adjustment
Adjust Printer Settings
5/22/17 ZT600 Series™ User Guide P1088680-001
TOOLS > MEDIA/RIBBON CAL
Calibrate the printer to adjust the sensitivity of the media and ribbon sensors.
For complete instructions on how to perform a calibration procedure, see Calibrate the Ribbon
and Media Sensors on page 192.
TOOLS
—
PRINT INFORMATION
—
IDLE DISPLAY
—
POWER UP ACTION
—
HEAD CLOSE ACTION
—
LOAD DEFAULTS
—
MEDIA/RIBBON CAL
—
DIAGNOSTIC MODE
—
ENERGY STAR
—
CONFIG INFO TO USB
—
ZBI ENABLED?
—
RUN ZBI PROGRAM
—
STOP ZBI PROGRAM
—
PRINT USB FILE
—
COPY USB FILE TO E:
—
STORE E: FILE TO USB
—
PRINT STATION
—
PASSWORD PROTECT
—
APPLCTR ERR: PAUSE
—
PRINT TEST FORMAT
Related ZPL command(s): ~JC
SGD command used:
ezpl.manual_calibration
Control panel key(s): Hold
PAUSE + FEED + CANCEL for 2 seconds to initiate calibration.
Printer web page: The calibration procedure cannot be initiated through the web pages. See the
following web page for settings that are set during sensor calibration:
View and Modify Printer Settings > Calibration
Important • Do not change these settings unless you are told to do so
by Zebra Technical Support or by an authorized service technician.