247
Diagnostics and Troubleshooting
Troubleshooting—Alerts and Error Messages
5/22/17 ZT600 Series™ User Guide P1088680-001
STATUS light steady red
PAUSE light steady yellow
Caution • The cutter blade is sharp. Do not touch or
rub the blade with your fingers.
The cutter blade is in the
media path.
Turn off the printer power and
unplug the printer. Inspect the
cutter module for debris and
clean as needed following the
cleaning instructions in Clean
the Cutter Module
on page 218.
The USB host port is disabled,
and a USB device was plugged
into the port.
To use the USB device, select
YES, or send the following
SGD command to the printer:
! U1 setvar
"usb.host.lock_out" "on"
There is not enough memory
to perform the function
specified on the second line of
the error message.
Free up some of the printer’s
memory by adjusting the label
format or printer parameters.
One way to free up memory is
to adjust the print width to the
actual width of the label
instead of leaving the print
width set to the default. See
PRINT WIDTH on page 110.
Ensure that the data is not
directed to a device that is not
installed or is unavailable.
If the problem persists, call a
service technician.
Display/
Indicator Lights
Possible Causes Recommended
Solutions
USE USB MEMORY
DEVICE?
YES NO
OUT OF MEMORY
STORING GRAPHIC
OUT OF MEMORY
STORING FORMAT
OUT OF MEMORY
STORING BITMAP
OUT OF MEMORY
STORING FONT
To Next Page
Loading...