Zebra ZT610 - Page 267

267
Using the USB Host Ports and the NFC Capabilities
USB Host
5/22/17 ZT600 Series™ User Guide P1088680-001
Exercise 1: Advanced User Information
See the Zebra
®
Programming Guide for more information about these commands.
Enable/disable mirroring:
! U1 setvar "usb.mirror.enable" "value"
Values: "on" or "off"
Enable/disable automatic mirroring that occurs when a USB Flash drive is inserted into the
USB host port:
! U1 setvar "usb.mirror.auto" "value"
Values: "on" or "off"
Specify the number of times that the mirror operation will be repeated if it fails:
! U1 setvar "usb.mirror.error_retry" "value"
Values: 0 to 65535
Change the path to the location on the USB device from which mirror files are retrieved:
! U1 setvar "usb.mirror.appl_path" "new_path"
Default: "zebra/appl"
Change the path to the location on the printer from which mirror files are retrieved:
! U1 setvar "usb.mirror.path" "path"
Default: "zebra"
Enable/disable the ability to use the USB port:
! U1 setvar "usb.host.lock_out" "value"
Values: "on" or "off"